Healthy Rips Rogue Dry Herb Vaporizer Manual

The Healthy Rips ROGUE Dry Herb Vaporizer is a portable and user-friendly device that offers an exceptional vaping experience with features designed for efficiency and convenience. Below is a detailed manual to help you make the most of your vaporizer.

• Plug the USB-C charging cord into the charging port located on the bottom of the device.
• Charge the unit for 2 hours before first use. The battery icon will show full when charging is complete.
• Do not use the unit while charging and avoid charging overnight or unattended.
• When the battery level is low, recharge the unit using the included USB-C cord.

• Press the Power Button located on the side rapidly 3 times within 2 seconds to turn the device on or off.
• The device will vibrate to signal activation or deactivation.

• Use the plus (+) and minus (-) buttons next to the OLED screen to adjust the temperature to your preference, between 280°- 430°F.
• The OLED screen will display the current temperature, and the device will vibrate once the desired temperature is reached.

• Press and hold the Power Button and the minus (-) button simultaneously for 2 seconds to switch between Fahrenheit and Celsius.

• Press and hold the Power Button for 3 seconds to flip the display screen, making it easier to use with water pipes.

• Press and hold the Power Button and the plus (+) button at the same time for 2 seconds to enter the timer 'Set' mode.
• Use the plus (+) or minus (-) buttons to adjust the timer between 3-8 minutes.

• Push out the mouthpiece to expose the chamber.
• Load dry herbs loosely into the chamber. Do not pack tightly to facilitate efficient convection heating.
• Replace the mouthpiece.

• Push out the accessories attachment.
• Load herbs loosely into the chamber.
• Insert the glass mouthpiece into the accessories attachment.

• Remove the mouthpiece and empty the chamber.
• Use the included cleaning brush to remove remaining material from the chamber.
• For deep cleaning, remove the silicone O-ring and screen from the mouthpiece, brush them with ISO alcohol, rinse with water, and dry thoroughly.
• Use a dampened Q-tip with ISO alcohol to clean the chamber and glass mouthpiece, avoiding liquid drip into the chamber.
• Reassemble and place the cleaned parts back onto the device, and turn it on for 2 minutes to burn off any cleaning residue.

• Remove the mouthpiece.
• Remove the O-ring and screen.
• Replace or clean the screen and O-ring.
• Reinstall the O-ring and screen back onto the mouthpiece.