Yocan Wulf Evolve Maxxx 3-in-1 Dab Pen Manual

The Yocan Wulf Evolve MAXXX 3-in-1 Dab Pen, Rig & Nectar Collector is a versatile device designed for optimal vaping experiences. It boasts a dependable battery, multiple heating elements, and a variety of configurations to suit different vaping preferences. This manual will guide you through preparing, using, and maintaining your device.

1. Ensure the Evolve MAXXX battery is fully charged before initial use.
2. To turn on the device, press the power button 5 times quickly (within 2 seconds). The power button is located in the middle part of the battery and is squarish with illuminated sides when powered on.

Wax Pen and Dab Rig Mode

1. Prepare your wax concentrates and keep them in a wax container.
2. Access the coils by unscrewing the mouthpiece from the base.
3. Remove the coil cap by twisting it counterclockwise.
4. Carefully load the wax concentrates into the coils.
5. Close the coil cap by twisting it clockwise.
6. Replace the mouthpiece by screwing it back in place.

Nectar Collector Mode

1. Prepare your wax concentrates and place them in a glass jar.
2. Note: In this mode, you do not load the concentrates directly into the vaporizer; you will dip the atomizer tip into the jar.

Wax Pen Mode

1. Ensure the device is fully charged and loaded with your selected wax concentrates.
2. Press your lips near the mouthpiece and prepare to inhale.
3. Press and hold the power button until vapor is produced, then draw from the mouthpiece.
4. Repeat the process after the extracts are vaporized, or stop after a full cycle.

Nectar Collector Mode

1. Ensure the device is fully charged.
2. Take the touch-tip coil, and dip or hover it over the wax concentrates in the jar.
3. Press and hold the power button until vapor is produced, then draw from the mouthpiece.
4. Repeat the process after the extracts are vaporized, or stop after a full cycle.

Dab Rig Mode

1. Ensure the device is fully charged and loaded with your selected wax concentrates.
2. Connect the water pipe attachment at the bottom and place it on your rig.
3. Press your lips near the mouthpiece of the rig and prepare to inhale.
4. Activate the pre-heat function by pressing the power button twice, then draw from the rig as vapor is produced.
5. Repeat the process after the extracts are vaporized, or stop after a full cycle.

1. Wipe off any dirt or residue from the battery with a dry paper towel.
2. Reassemble the vaporizer after cleaning.
3. Follow charging instructions and use the dedicated charger to avoid damage.