Yocan Wulf Kodo Pro 510 Thread Vape Cart Battery Manual

Welcome to the comprehensive guide for the Yocan Wulf KODO Pro 510 Thread Vape Cart Battery. This manual will assist you in operating and maintaining your device for an enhanced vaping experience.

1. Use a compatible USB type-C charging cable. Connect it to a USB type-C compatible wall adapter.
2. Connect the USB type-C tip to the device and the wall charger to a wall outlet.
3. Wait for the battery to recharge.
4. Note: The device does not include a USB type-C charging cable or a wall charger. You can also connect the USB type-C to your computer if a wall charger is not available.
5. CAUTION: Avoid charging with any powerbank of 5V or above. Refrain from overcharging the device as it may lead to battery damage. Car charging is also not recommended.

1. Ensure that the device is fully charged for optimal performance.
2. Press the power button five times. The power button is located on top of the digital OLED screen and is squarish in shape.
3. Wait for the digital OLED screen to turn on, indicating that the device is ready.

1. Make sure the device is powered on.
2. Press the (+) button on the right side to increase the voltage level by 0.1 volts.
3. Press the (-) button on the left side to decrease the voltage level by 0.1 volts.
4. When you have selected your preferred voltage, release the (+) or (-) buttons.

1. Ensure the device is powered on.
2. Press the power button twice to enter the preheat mode.
3. Press the power button twice again to cancel the preheat function.

1. Ensure the device is turned on.
2. Long press the power button for three seconds.
3. The device will heat for 15 seconds while in sesh mode. The OLED display will flash "Over Time" for two seconds once the sesh mode is complete.

1. Power on the device.
2. On the digital OLED screen, check the lower left area for the puff counter, indicated by a "P" at the end of the count.
3. Once the puff counter reaches 9999, it will reset automatically. To reset manually, click the power button and the (-) button simultaneously.

1. It is best to connect the cartridge when the device is off.
2. Take your refillable or prefilled cartridge and attach it to the 510-threaded link.
3. Turn it clockwise to tighten the connection.
4. To remove, turn the cartridge counter-clockwise.
5. Note: To prevent issues when connecting the cartridge, stop tightening when you feel some resistance. Overtightening could cause the battery to not read the cartridge. If issues occur, remove and replace the cartridge.

1. Remove the cartridge by following the previously mentioned steps.
2. Use a cotton swab to gently clean the 510-threaded connections on the device.
3. Use the same cotton swab to clean the metal contacts of your refillable or pre-filled cart.
4. If the device has oil spills and smudges on the body, use a dry cloth or paper towel to remove the oil spills.

1. Get your lanyard or wrist lace.
2. Insert the loop on the side of the device.
3. Note: The device does not come with a lanyard.