Yocan Wulf Ari Slim Vape Pen Starter Kit Manual
Welcome and thank you for purchasing the Yocan Wulf ARI Slim 510 Thread Cart Pen Vape Battery. This manual will guide you through the use and maintenance of your device for an exceptional vaping experience.
How to Turn On and Off the Yocan Wulf ARI Slim 510 Thread Cart Pen Vape Battery
The power button is located at the upper part of the battery, identified as a square-shaped button that lights up when activated.
- To turn on the vape battery, press the power button five times quickly within 3 seconds.
- To turn off the vape battery, press the power button five times quickly again.
Charging the Yocan Wulf ARI Slim Kit
- Insert the Type-C charging cable into the port at the bottom of the device.
- The initial charge requires 2 hours, while subsequent charges take about 1 hour.
- Avoid overcharging beyond 1 hour to prevent device damage.
- WARNING: Do not charge with a power bank of 5V or higher. Do not charge in your car.
Loading Your Concentrates in ARI Slim's Quartz Coil Chamber
- Unscrew the quartz coil concentrate chamber from the mouthpiece.
- Place your concentrate inside the chamber.
- Screw the mouthpiece back on, then attach the chamber to the device.
Operating the Variable Voltage Settings
- Locate the bottom part of the battery where the variable voltage knob resides.
- Twist the knob to select your desired voltage setting between 1.8V and 4.2V.
Using the 10-Second Preheat Function
- To initiate preheat, press the power button twice quickly. The device will preheat for 10 seconds.
- To cancel preheating, press the power button once during the preheat cycle.
Troubleshooting Your Yocan Wulf ARI Slim
- If no chamber or cartridge is detected, the power button will flash a white light three times.
- Holding the power button for 15 seconds results in a white light that flashes five times and then goes off.
Loading and Using the Yocan Wulf ARI Slim for Vaping
Using Wax Concentrates
- Ensure the battery and wax coil are connected properly using the 510-threaded connection.
- Sanitize new coils by holding the power button for 3-5 seconds two or three times.
- Load wax concentrates with a dab tool, ensuring the tool doesn't touch the coil directly.
- Replace the mouthpiece and other necessary parts.
Using Oil Cartridges
- Fill refillable oil cartridges before connecting them to the device.
- Check and clean the 510-thread connections if needed.
- Connect the oil cartridge by twisting it clockwise until snug.
- Replace the mouthpiece and other parts.
Care and Maintenance
- Turn off the vaporizer by pressing the power button five times.
- If using a wax coil, turn the vape upside down and perform a burn-off by holding the power button for five seconds. Repeat two to three times to remove residue.
- Allow the vaporizer to cool and dismantle by unscrewing the cartridge or coil.
- Clean 510-threaded connections with a cotton swab, and wipe any oily residue from the battery with a dry paper towel.
- Reassemble the vaporizer when clean.